Enercon Digital
AC Monitoring & ControlBuilding tier · solution

Cut AC energy by a quarter without replacing a single unit.

25% typical, and up to 40% where metering finds fault or unauthorised use.

Book a Site Assessment
The hidden drain

Air conditioning is the largest controllable load in your building.

A bank of split-system condenser units on a commercial rooftop, pipework running between them

In most Pakistani commercial facilities it accounts for up to 80% of consumption — and almost none of it is measured at the unit.

The approach

Measure every unit, then enforce the policy on the unit.

A module goes between the supply and each air conditioner. It meters what that unit draws and switches it, so occupied hours and setpoint floors are held in hardware rather than on a wall panel anyone can override. The air conditioners are not replaced and not rewired.

BasisTypical across audited commercial sites, measured against a weather-normalised pre-install baseline. The 40% upper bound is not a typical result.
See the module and its specification

What running an estate this way is like

Multi-site controlBranches, floors and zones from one interface, with policy set once and applied across the estate.
Fault and misuse alertsTampering, an out-of-policy override or a unit drawing outside its envelope raises a notification, not a surprise on the next bill.
No rewiringThe module sits between the supply and the unit, across split and package types. Nothing about the air conditioners changes.
Installed, trained, supportedThe estate is handed over running, not shipped in a box.

Put your own numbers in and see when the install pays for itself.

What Enercon would save you

Commercial · Pakistan

Interactive demo · sample data
What you spend against what you save
?The flat dashed line is what the system costs you. The rising line is what it saves. Where they cross is the month you have got your money back — everything after that is yours.
Break even · month 60.01m0.01mUSD 0now122436 months
What it costs youWhat it saves youThe month you break even
You break even after6months

After that, the saving is yours to keep.

Saved each month293USD
Saved over three years10600USD
Your building
per site
tons per unit
approved running
outside those hours
open
for every figure
USD per kWh
optional
Saving we assume
?How much less energy the units use during your authorised hours once setpoints are controlled. We start at the low end of what we have measured, and you can drag it lower.
22%

We have measured 10% to 40% on commercial sites. This starts at the low end. Drag it lower if your building already runs schedules.

Reference ACMC-SAV-01 · figures to be confirmed
Where the saving comes from
?Two separate things. One: units running when they are not meant to — after closing, weekends, empty rooms — which a schedule on the device stops outright. Two: units set too cold during your own working hours, which a setpoint floor prevents.
Stopping unauthorised use140USD a monthA schedule held on the unit itself. Running after closing, at weekends or in an empty room simply does not start, and nobody can override it on the way out.
Stopping over-cooling154USD a monthA floor on the setpoint during your authorised hours, so a unit cannot be dropped to 16 °C and left there.
You use now4,930kWh a monthUSD 838 a month
You would use3,200kWh a monthUSD 545 a month

Figures are indicative and confirmed by an on-site assessment.

Send me this as a PDF

Optional — the figures stay on screen either way
12 units at 1.5 tons · 10 authorised hours a day plus 2 unauthorised.

Four more demos — the live console, schedules, setpoints and shed order. See all five

Book a site assessment

Two engineers, one day on site, a written report with measured baseline and modelled payback.

Book a Site Assessment